stab_c_fil

Gas Governors

Gas governors with filter

CSA design certified Z21.80/ CSA 6.22 Class I Line Pressure Regulator for 2 psig inlet pressure, outlet pressure range of 2 inches w.c. to ½ PSIG. The GOVERNOR allows for vent limited*, multi-position installation, and positive dead-end lockup for ½ through 4". The GAS GOVERNOR also features double diaphragm, integral vent limiter with balanced valve design to provide increased capacity and accuracy. The GOVERNOR is suitable for indoor and outdoor installation. The GOVERNOR is also certified ANSI Z21.18 (appliance regulators).

CSA design certified Z21.80/ CSA 6.22 Class I Line Pressure Regulator with Over Pressure Protection (OPD) for 5 psig inlet pressure, outlet pressure range of 2 inches w.c. to ½ PSIG. The GAS GOVERNOR allows for vent limited*, multi-position installation and positive dead-end lockup for ½ through 2". The GAS GOVERNOR also features double diaphragm, integral vent limiter with balanced valve design to provide increased capacity and accuracy. The GAS GOVERNOR is suitable for indoor and outdoor installation.

GAS GOVERNOR non-certified models are available from ½" through 4" pipe size, up to 7 psig inlet pressure and 2 psig outlet pressures. Integral slam-shut valves and filters are available. The GAS GOVERNOR is suitable for indoor and outdoor installation.

*Where local codes allow

TECHNICAL DATA

Range of inlet pressure bpu +2,5 mbar a +500 mbar - +1 or 201 wc in comparison to the outlet nominal pressure
Outlet pressure range of Wd 5÷300 mbar
Accuracy class 15
Closing pressure class SG Pd+7.5 mbar o +30% according to EN88-1
Threaded connections vedi catalogo
Design pressure 1 bar
Design temperature 2 (-20°C +60°C)